Boundedness of semilinear Duffing equations at resonance in a critical situation

In this paper, we propose a sufficient and necessary condition for the boundedness of all the solutions for the equation $\ddot{x}+n^{2}x+g(x)=p(t)$ with the critical situation that $|{\int }_0^{2\pi }p(t)e^{?int}dt|=2|g(+\infty )?g(?\infty )|$ on g and p, where $n\in {\mathbb{N}}^{+}$, $p(t)$ is periodic and $g(x)$ is bounded.     

Identifying anomalous Floquet edge modes via bulk-edge correspondence

Floquet engineering appears as a new protocol for designing topological states of matter,and features anomalous edge modes pinned at quasi-energy π/T with vanished topological index.We propose how to predict the anomalous edge modes via the bulk Hamiltonian in frequency space,and use Zak phase to quantitatively index the topological properties.The above methods are clarified by the example of time periodic Kitaev chain with chemical potential of harmonic driving and pulse driving,and topological phase transitions are manifested at different driving frequencies.     

高雷诺数下非混相Rayleigh-Taylor不稳定性的格子Boltzmann方法模拟

本文采用相场格子Boltzmann方法研究了竖直微通道内中等Atwoods数流体的单模Rayleigh-Taylor不稳定性问题,系统分析了雷诺数对相界面动力学行为以及扰动在各发展阶段演化规律的影响.数值结果表明高雷诺数条件下,不稳定性界面扰动的增长经历了四个不同的发展阶段,包括线性增长阶段、饱和速度阶段、重加速阶段及混沌混合阶段.在线性增长阶段,我们计算获得的气泡与尖钉振幅符合线性稳定性理论,并且线性增长率随着雷诺数的增加而增大.在第二个阶段,我们观察到气泡与尖钉将以恒定的速度增长,获得的尖钉饱和速度略高于Goncharov经典势能模型的解析解[Phys.Rev.Lett.200288134502],这归因于系统中产生了多个尺度的旋涡,而涡之间的相互作用促进了尖钉的增长.随着横向速度和纵向速度的差异扩大,气泡和尖钉界面演化诱导产生的Kelvin–Helmholtz不稳定性逐渐增强,从而流体混合区域出现许多不同层次的涡结构,加速了气泡与尖钉振幅的演化速度,并在演化后期阶段,导致界面发生多层次卷起、剧烈变形、混沌破裂等行为,最终形成了非常复杂的拓扑结构.此外,我们还统计了演化后期气泡与尖钉的无量纲加速度,发现气泡和尖钉的振幅在后期呈现二次增长规律,其增长率系数分别为0.045与0.233.而在低雷诺条件下,重流体在不稳定性后期以尖钉的形式向下运动而轻流体以气泡的形式向上升起.在整个演化过程中,界面变得足够光滑,气泡与尖钉在后期的演化速度接近于常数,未观察到后期的重加速与混沌混合阶段.     

Convergence of the viscosity solution of non-autonomous Hamilton-Jacobi equations

In this paper,we investigate the non-autonomous Hamilton-Jacobi equation ■ where H is 1-periodic with respect to t and M is a compact Riemannian manifold without boundary.We obtain the viscosity solution denoted by T_(t_0)~tφ(x) and show T_(t_0)~tφ(x) converges uniformly to a time-periodic viscosity solution u~*(x,t) of ?_tu+H(t,x,?_xu,u)=0.     

Eu:Lu2O3透明闪烁陶瓷的制备与性能

采用湿化学法合成了Eu原子掺量5%的Lu₂O₃陶瓷前驱体,通过SEM、XRD研究了煅烧前后前驱体和1 100 ℃煅烧4 h后粉体的形貌、结构以及物相。结果表明煅烧后的粉体为纳米类球形、高分散且结晶性良好的颗粒。颗粒尺寸为68.5 nm。使用煅烧后的粉体为原料,在1 650 ℃真空烧结30 h制备了高透过率的Eu:Lu₂O₃陶瓷,晶粒尺寸为46 μm,在611 nm处的直线透过率可以达到66.3%。此外对陶瓷的吸收曲线、光致激发和发射光谱特性以及X射线激发发射光谱进行研究。可观察到,Eu:Lu₂O₃陶瓷存在基质和激活离子两类吸收,光致发光光谱和X射线激发发射光谱均可以看出Eu:Lu₂O₃陶瓷存在极强的⁵D₀→⁷F₂跃迁发光,位于611 nm处。对比商业的BGO单晶的X射线发射光谱,可得本实验中制备的陶瓷的光输出为85 000 ph/MeV。Eu:Lu₂O₃陶瓷本身有着高X射线以及高能粒子的阻止能力,结合高光输出特性,表明Eu:Lu₂O₃陶瓷在X射线成像等领域具有巨大的潜在应用价值。     

DFT mechanistic study of the H2‐assisted chain transfer copolymerization of propylene and p‐methylstyrene catalyzed by zirconocene complex

DFT computations have been performed to investigate the mechanism of H₂‐assisted chain transfer strategy to functionalize polypropylene via Zr‐catalyzed copolymerization of propylene and p‐methylstyrene (pMS). The study unveils the following: (i) propylene prefers 1,2‐insertion over 2,1‐insertion both kinetically and thermodynamically, explaining the observed 1,2‐insertion regioselectivity for propylene insertion. (ii) The 2,1‐inserion of pMS is kinetically less favorable but thermodynamically more favorable than 1,2‐insertion. The observation of 2,1‐insertion pMS at the end of polymer chain is due to thermodynamic control and that the barrier difference between the two insertion modes become smaller as the chain length becomes longer. (iii) The pMS insertion results in much higher barriers for subsequent either propylene or pMS insertion, which causes deactivation of the catalytic system. (iv) Small H₂ can react with the deactivated [Zr]?pMS?PP_n facilely, which displace functionalized pMS?PP_n chain and regenerate [Zr]? H active catalyst to continue copolymerization. The effects of counterions are also discussed. © 2014 Wiley Periodicals, Inc. J. Polym. Sci., Part A: Polym. Chem. 2015 , 53, 576–585     

Flame-retardant effect of cross-linked phosphazene derivatives and pentaerythritol derivatives on polypropylene

Journal of Thermal Analysis and Calorimetry - A phosphazene-based flame retardant (PBFA) was synthesized by hexachlorocyclotriphosphazene and N-aminoethylpiperazine. To improve the flame retardancy...     

A Photoactivated Cu–CeO2 Catalyst with Cu-[O]-Ce Active Species Designed through MOF Crystal Engineering

Fully utilizing solar energy for catalysis requires the integration of conversion mechanisms and therefore delicate design of catalyst structures and active species. Herein, a MOF crystal engineering method was developed to controllably synthesize a copper–ceria catalyst with well-dispersed photoactive Cu-[O]-Ce species. Using the preferential oxidation of CO as a model reaction, the catalyst showed remarkably efficient and stable photoactivated catalysis, which found practical application in feed gas treatment for fuel cell gas supply. The coexistence of photochemistry and thermochemistry effects contributes to the high efficiency. Our results demonstrate a catalyst design approach with atomic or molecular precision and a combinatorial photoactivation strategy for solar energy conversion.